判斷破碎錘大小基本的就是參考釬桿直徑的大小，那么，挖掘機配破碎錘的時候，目前簡單的就是參考挖掘機的重量，如下表（僅供參考）：釬桿直徑mm4553687585100135140155165175適配車重ton1.2-3.02.5-4.54.0-7.06.0-9.07.0-1411-1618-2318-2628-3530-4540-55
The basic way to determine the size of the crushing hammer is to refer to the diameter of the drill rod. Therefore, when matching the crushing hammer with an excavator, the current simple method is to refer to the weight of the excavator, as shown in the table below (for reference only): the diameter of the drill rod mm4553687585100135140155165175, suitable for vehicle weight ton1.2-3.02.5-4.54.0-7.06.0-9.07.0-1411-1618-2318-2628-3530-4540-55
除此之外，還可以作為參考的有以下三個方面：
In addition, the following three aspects can also be used as references:
①挖掘機的油量：破碎錘的工作主要是依靠挖掘機的液壓，所以，只有從挖掘機獲得合適的液壓，破碎錘才能發揮其佳性能。而一般情況下，破碎錘的流量為適配挖掘機流量的60%-80%。
① The oil volume of the excavator: The work of the crushing hammer mainly relies on the hydraulic pressure of the excavator, so only by obtaining appropriate hydraulic pressure from the excavator can the crushing hammer achieve its best performance. In general, the flow rate of the crushing hammer is 60% -80% of the flow rate of the suitable excavator.
②挖掘機的吐出壓力：一般情況下，破碎錘的工作壓力在低于挖掘機的常用壓力的30-40bar的時候，破碎錘才能發揮出佳力量。
② The discharge pressure of the excavator: Generally, the working pressure of the crushing hammer is 30-40bar lower than the commonly used pressure of the excavator, and the crushing hammer can only exert its best force.
③挖掘機的提升能力：由于破碎錘是安裝在挖掘機上使用的設備，所以挖掘機的提升能力必須能承受破碎錘的重量。否則挖掘機會有顛覆的可能，從而無法正常工作并且有安全隱患！
③ The lifting capacity of the excavator: As the crushing hammer is a device installed on the excavator, the lifting capacity of the excavator must be able to withstand the weight of the crushing hammer. Otherwise, there is a possibility of subversion in mining opportunities, resulting in inability to work properly and potential safety hazards!
破碎錘作業危險系數比較高，在此，軍恒機械在此也提醒廣大客戶，一定要注意安全。作業時駕駛室首先要安裝防護網，然后要觀察作業現場附近是否有人員走動，以防有碎石塊蹦出對人身造成傷害。
The risk factor of crushing hammer operation is relatively high. Here, Junheng Machinery also reminds customers to pay attention to safety. When working, the driver's cab should first be equipped with a protective net, and then observe whether there are any people moving around the work site to prevent any broken stones from jumping out and causing personal injury.
